Kidd's Camo Stock Project
"Uniqueness is my weakness"
By Klayton Kidd
Shhhhhhhhh....Amy slipped him a roofie.
(Click on any image to enlarge)
Taken from the Crosman Forum. Used with permission.
http://www.network54.com/Forum/275684/message/1160453895/How+To-+Camo+Painting............with+pics
Though
not an airgun, my recently purchased .223 coyote rifle needed to be painted in a
camo pattern. Here is what I did to make a high desert camo paint job that sorta
matches my camo clothing. The hardest part was taking a brand new rifle and
scope set up, and performing the following steps (irreversible in most ways).
Anywho here is what I did.
First I picked up the major colors I would need in Ultra Flat Camo Paint from
the hardware store. $6 a can, but enough to do many many rifles, or other
things.
I
also was fortunate that my girlfriend is into scrapbooking, and has many
differnt stencils lyin around. Picked a few out that I thought would work well.
Next is masking off that which you do not want to be covered in paint. For me, I covered the yardage and power markings, as well as making darn sure that the lenses were covered. I used 3M Professional masking tape.
Next
is that hard part, after this step it is near impossible to go back, so BE
ABSOLUTELY SURE you wish to paint your rifle at this point.
So now that it is masked up, use a scotch pad to scuff every surface you wish to
paint, this ensures proper adhesion. Be sure to do a good job, as any smooth
surfaces will be prone to flaking and chipping.
Next
I hung the gun from a strap stud and cleaned all oil from the gun using a volatile
solvent, so that it dries fast. After cleaning it do not touch the surface with
bare fingers.
At this point you are ready to lay your base color. Here in the desert we have a
LOT of tan, so I used that as my base. Again, here work from a set of camo
clothes that you know to work well in your area.
It is also important to take proper safety precautions. You will notice I am
inside. Because of that i put a fan blowing air out of the garage, and used a
professional, microm painters mask. These fumes are harmful, and proper
ventilation is key, outside being best. If you do for any reason start to feel nauseous,
stop immediately and sit down away from the area. Get fresh air and if problems
increase of persist, contact emergency care.
(webmaster's comment: "Luke...I am your father")
I painted the gun a base tan...
...then using the stencils started layering the other colors.
Don't
worry, you can always add layers of colors to achieve your desired effect. Once
you are satisfied, it simply becomes the waiting game for it to dry. I recommend
at least 24 hours before any serious use. The nice thing is that you can alter
the design by simply starting over at the masking stage. After time the paint
will wear off in high use areas, so it will be necessary to touch up the paint
every so often.
The final product is ready for some field testing.
Hope this helps!!